Foxconn 755 series User Manual page 32

Wake-up on Modem: WOM
Through this function, systems in suspend or soft-off mode can be waked up by
a ring signal received from the internal modem. When this function is used, be
sure an internal modem card which supports this function is used. Then con-
nect the header to the relevant connector on the modem card, set "RING Power
Up Control" to "Enabled" in the "Power Management Setup" section of the CMOS
SETUP. Save and exit, then boot the operating system once to make sure this
function takes effect.
S-ATA Connectors: SATA1, SATA2, SATA3, SATA4
The S-ATA header is used to connect the S-ATA device to the motherboard.
These connectors support the thin Serial ATA cables for primary internal storage
devices. The current S-ATA interface allows up to 150MB/s data transfer rate.
There are four S-ATA connectors on the motherboard.
24
755A01-032604.p65
Chapter 2 Installation Instructions
755/760A01 Series User Manual
24
Modem wake up
GND
1 5V_SB_SYS
WOM
GND
T X +
TX-
GND
RX-
RX+
GND
S-ATA1/S-ATA2
S-ATA3/S-ATA4
2004-3-26, 15:28