Foxconn K8S755A series Manual page 32

Wake-up on Modem: WOM
Through this function, systems in suspend or soft-off mode can be waken up by
a ring signal received from the internal modem. When this function is used, be
sure an internal modem card which supports this function is provided. Then
connect the header to the relevant connector on the modem card, set "RING
Power Up Control" as "Enabled" in the "Power Management Setup" section of
the CMOS Setup. Save and exit, then boot the operating system once to make
sure this function takes effect.
S-ATA Connectors: SATA1,
The S-ATA headers are used to connect the S-ATA devices to the motherboard.
These connectors support the thin Serial ATA cables for primary internal storage
devices. The current S-ATA interface allows up to 150MB/s data transfer rate.
There are four S-ATA connectors on the motherboard.
24
Chapter 2 Installation Instructions
K8S755A Series User Manual
24
Modem wake up
GND
5V_SB_SYS
WOM
1
GND
TX+
TX-
GND
RX-
RX+
GND
S-ATA1/S-ATA2
S-ATA3/S-ATA4
2004-9-22, 17:16