Range Hood Controls; Range Hood Care; Cleaning - Whirlpool UXT3030AYW0 Installation Instructions And Use & Care Manual

ng® '° ..........
UXT20, UXT_ and UXT40 Series Models
Off
On _)Off Low@ High
A B
A. On/Off light switch
B. Fan speed switch
Operating the light
Push the light switch to the right to turn the light Off. Push the
light switch to the left to the turn the light On.
Operating the fan
Push the fan switch to the left for Low speed. Push the fan
switch to the right for High speed. Push the fan switch to the
middle for Off.
UXT42 Series Models
LOW_O_FF_ ,IGH
z' / _:
A
OFF
B
A. Fan speed switch
B. On/Off light switch
LOW
Operating the light
Turn the light switch to the right 1 position for Low (night light).
Turn the light switch to the right 2 postions for High.
Operating the fan
The fan is variable speed. Rotate the fan switch to the right to
turn the fan to the ON position. Continue to rotate the switch to
the desired fan speed.
To turn the fan OFF, rotate the fan speed switch to the left to the
OFF position.
UXT52 Series Models
A B C D
ON/OFF ON/OFF Med High
©©©©)
A. On/Off light button
B. Blower off and speed minimum button
C. Blower speed medium button
D. Blower speed maximum button
Operating the light
The On/Off light button controls both lights. Press once for On
and again for Off.
Operating the blower
The BLOWER SPEED buttons turn the blower on and control the
blower speed and sound level for quiet operation. The speed can
be changed anytime during fan operation by pressing the desired
blower speed button.
Press the BLOWER OFF button a second time to turn the blower
off.
RANGE HOOD CARE
IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease filter
before operating hood.
Exterior Surfaces:
IMPORTANT: Do not use soap-filled scouring pads, abrasive
cleaners, Cooktop Polishing Creme, steel wool, gritty washcloths
or paper towels.
To avoid damage to the stainless steel, do not use cleaners that
contain chlorine.
Cleaning Method:
• Rub in direction of grain to avoid scratching or damaging the
surface.
For stainless steal models, Stainless Steel Cleaner and Polish
Part Number 31462A (not included): See "Assistance or
Service" section to order.
• Liquid detergent or all-purpose cleaner:
Rinse with clean water and dry with soft, lint-free cloth.
• Glass cleaner to remove fingerprints.
Metal Grease Filter (UXT20, UXT30, UXT40 and
UXT42 Series Models)
For vented installations:
1. Remove screw from the grease filter retainer.
2. Turn the grease filter retainer to release filter.
A. Filter retainer
3. Wash metal filters as needed in dishwasher or hot detergent
solution.
4. Reinstall the filter by placing the back edge in the channel at
rear of hood. Push filter into place, turn the filter retainer to
secure filter to range hood.
5. Replace screw in the grease filter retainer.
13