Assembly - Weslo BODYSHOP 831.150490 User Manual

ASSEMBLY
Before beginning assembly, carefully read the THE FOLLOWING TOOLS (NOT INCLUDED) ARE
following information and Instructions: REQUIRED FOR ASSEMBLY:
• Place all parts of the BODYSHOP in a Cleared
area and remove the packing matedals; do not
dispose of the packing materials until assembly is
completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• For help identifying the small pads used in
assembly, use the PART IDENTIFICATION
CHART below.
• As you assemble the BODYSHOP, be sure that
all parts are oriented as shown in the drawings.
PART IDENTIFICATION CHART
This chart is provided to help you ideniify the small
pads used in assembly. Important: Some parts may
have been pre-assembled for shipping purposes.
If you cannot find a part in the parts packet, check
• Two (2) adjustable wrenches
• One (1) rubber mallet
• The included allen wrench
• The Included lubricant and a small amount of
warm soapy water will also be needed for
assembly.
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches, or a set of ratchet wrenches.
to see if it has been pre-assembled. The number in
parenthesis below each part refers to the key number
of the part. The second number refers to the quantity
needed for assembly.
1/2" Bushing (31)-2
Q
• 1/2" Axle Cap (7)-6
1/4. Nylon Locknut (1)--4
1/4" x 1" Screw (2)-4
3/8" Washer (30)-2
I
1 3/4" Pin (25)-2
3/8" x 2 1/4' Carriage Bolt (33)-2
3/8" Nylon Locknut (34)-2
1/4" x 2" Bolt (3)-2