Table of Contents
Advertisement
ASSEMBLY
Place all parts of the CARDIO GLIDE in a cleared area and remove the packing materials. Do not dispose of the
packing materials until assembly is completed. Read each step carefully before beginning.
Assembly requires the following tools: one phillips screwdriver
1. Tap a 1/2" Bushing (25) into each side of the Frame
(6) as shown.
Apply grease to the Pivot Rod (21). Align the holes in
the Pedal Frame (7) with the indicated tube on the
Frame (6). Tap the Pivot Rod through the Pedal
Frame and the Frame.
IMPORTANT NOTE: Before assembling the 1/2"
Dome Caps (29), make sure that you thoroughly
understand the assembly step(s) they are used in.
They can be assembled only once. If they must be
removed, you will need to order new Dome Caps.
Center the Pivot Rod (21) and tap a 1/2" Dome Cap
(29) onto each end of it.
Make sure that the Magnet (27) is on the Pedal
Frame (7).
2. Make sure that there is a 1/2" Link Arm Bushing (19)
in the right Link Arm (4) (see the inset drawing). Slide
the Link Arm onto the indicated pin on the Pedal
Frame (7). Pivot the Pedal Frame and tap a 1/2"
Dome Cap (29) onto the pin.
Attach the left Link Arm (not shown) in the same man-
ner.
3. Make sure that there is a 1 1/4" x 2" Endcap (13) on
each end of the Handlebar (2). The Endcaps must be
turned so the round holes are on top.
Slide the Handlebar (2) into the Pedal Frame (7). The
Handlebar must be turned so the sides bend toward
the seat (not shown). Align the holes in the Handlebar
with the holes in the Pedal Frame. Attach one side of
the Handlebar with two #8 x 1/2" Screws (16). Attach
the other side of the Handlebar with two #8 x 1/2"
Screws.
Slide the 1 1/4" x 2" Endcaps (13) down over the
Pedal Frame (7).
4
, and one rubber mallet
, one adjustable wrench
.
Apply
1
Grease
21
29
6
25
27
2
4
19
4
3
2
7
7
29
7
29
Pin
19
13
16
Advertisement
Table of Contents
