Table of Contents
Advertisement
Inspect and tighten all parts each time you use the home gym system. Replace any worn parts immediately. The
home gym system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the home gym system, can stretch slightly when it is first used. If there
is slack in the cables before resistance is felt, the cables should be tightened. If any slack is felt when using the
weight stack closest to the ab upright, both the High Cable (85) and the Low Cable (86) will need to be tight-
ened. If any slack is felt when using the other weight stack, the Rear Cable (87), the Press Cable (88), and the
Butterfly Cable (89) will need to be tightened.
To tighten the cables, first insert the weight pin into the mid-
dle of the weight stack. Slack can be removed from these
cables several ways:
•
See drawing 1. Tighten the 1/4" Nylon Locknut (44) that
connects the end of the Press Cable (88) to the Large "U"
Bracket (84).
See drawing 1. Remove the 3/8" Nylon Locknut (42) and
the 3/8" x 2" Bolt (50) from the Pulley Covers (94), Pulley
and Large "U" Bracket (84). Re-attach the Pulley and
Pulley Covers to the other hole in the Large "U" Bracket.
Orient the wide tab on the Pulley Covers as shown and
make sure the Cable and Pulley move smoothly.
See drawing 2. Loosen the 1/2" Plain Nut (83) on the end
of the High Cable (85). Thread the Cable further into the
spider nut (not shown) in the end of the Weight Tube
(25). If the Cable needs to be tightened further, the 1/2" x
1 1/4" Weight Spacer (32) can be removed. The Rear
Cable (87) can be tightened in the same manner.
•
See Drawing 3. If you feel additional slack while using the
home gym system, the Low Cable (86) and the Press
Cable (88) can be tightened further.
Remove the 3/8" x 2" Bolt (50) and the 3/8" Nylon
Locknut (42) securing the lower 3 1/3" Pulley (82) and the
Pulley Covers (94) from the Pulley Plates (31). Re-attach
the lower Pulley to the higher hole in the Pulley Plates.
Be sure that the Cable and Pulley move smoothly.
Do not overtighten the cables. If the cables are overtight-
ened, the top weight will be lifted off the weight stack.
If a cable tends to slip off the pulleys often, it may have
become twisted. Remove the cable and re-install it.
Wide Tab _
._._
_94
42_
84_"_-
j5°
44
i--88
3
82-___
Wide Tab %
86, 88----
I
82
42
If the cables need to be replaced, see ORDERING
REPLACEMENT
PARTS on the back cover of this manual.
25
Hide quick links:
Advertisement
Table of Contents
