Weider PRO 9925 User Manual page 10

17. Attach a Press Arm (7) to one side of the Press
Frame (12) with two 5/16" x 2 1/2" Bolts (39) and two
5/16" Nylon Locknuts (40).
Attach the other Press Arm (7) to the Press Frame
(12) in the same manner.
39
18. Press a 1" Inner Cap (80) into the indicated end of
one Press Arm (7). Press a 1 3/4" Square Inner Cap
(48) into the Press Arm.
Repeat this step for the other Press Arm (not shown).
19. Lubricate both axles on the Butterfly Frame (3).
Refer to the drawing and identify the Right Arm (5)
and the Left Arm (6).
Press a 1 3/4" Square Inner Cap (48) into the upper
end of the Left Arm (6). Slide the Left Arm onto the
indicated axle, Note: Be careful not to confuse the
Left Arm with the Right Arm (5). Be sure that the
upper end of the Left Arm is behind the indicated
bracket on the Butterfly Frame (3).
IMPORTANT NOTE: Before assembling the 1"
Retainers (45) used in this step, be sure that you
thoroughly understand the step. The Retainers
can be assembled only once. If they must be
removed, you will need to order new Retainers.
Tap two 1" Retainers (45) and a 1" Round Outer Cap
(46) onto the axle, Be sure that the teeth on the
Retainers bend toward the Round Outer Cap, as
shown in the inset drawing.
Attach the Right Arm (5) in the same manner.
19
3
Axle
Bracket 45_
46
I
Lb:x,e
45__
10