Weider PRO 9925 User Manual page 12

23. Wrap the Butterfly Cable (89) around a "V" Pulley
(81) as shown. Attach the "V" Pulley to the bracket
on the Leg Press Upright (4) with a 3/8" x 2 1/2" Bolt
(65), a Large Cable trap (79) and a 3/8" Nylon
Locknut (42). Make sure the Cable Trap is oriented
as shown.
23
65
79
81
42
24. Locate one of the preassembled pairs of Pulley
Plates (31) and remove both 3 1/2" Pulleys (82).
Route the Butterfly Cable (89) around a 3 1/2" Pulley
(82) in the direction shown. Attach the Pulley and two
Pulley Covers (94) to the Pulley Plates (31) with a
3/8" x 2" Bolt (50) and a 3/8" Nylon Locknut (42).
Note: The end of the Pulley Plates (31) with two
holes should be pointed downward. The Pulley
Covers must be oriented as shown in the inset
drawing. Note that the wide tab is over the stress-
point, where the Cable wraps around the Pulley.
Use this orientation of the Pulley Covers in the
following assembly steps.
25. Wrap the Butterfly Cable (89) around a "V" Pulley
(81) as shown. Attach the "V" Pulley to the other side
of the bracket on the Leg Press Upright (4) with a
3/8" x 2 1/2" Bolt (65), a Large Cable Trap (79) and a
3/8" Nylon Locknut (42). Make sure the Cable Trap
is oriented as shown.
24
Wide Tab 94
42,
31
Two
Holes
25
89
26. Note: The Left Arm (6) is shown removed for easi-
er part identification. Insert a 5/16" x 1" Bolt (97)
through the bracket on the Left Arm. Fully tighten a
5/16" Nylon Jam Nut (91) onto the Bolt.
Slide the free end of the Butterfly Cable (89) onto the
5/16" x 1" Bolt (97). Thread another 5/16" Nylon Jam
Nut (91) onto the Bolt, but do not fully tighten it.
Leave enough room between the two Jam Nuts
for the Cable to pivot.
26
89
97
12