Settingup The Tv Guideon Screensystem - Toshiba 57H93 Owner's Manual

Settingup the TV GuideOn Screensystem
([continued)
3. Select your VCR brand, and tben press ENTER. Code
testing begins.
3. lithe correct code is not found, tbe following screens
appear, with helpful hints for finding the code.
VCR code testing
1. To allow the TV Guide On Screen system to find the
correct code for your brand of VCR, tune your VCR to
channel 02, turn the VCR OFF leave tbe TV ON, and
tben press ENTER.
Confirming your settings
1. Review the setup information displayed on your TV screen
(an example is shown below).
If the information on your TV screen is correct for your
setup, select YES, END THE SETUP PROCESS and press
ENTER.
If the information is incorrect, select NO, REPEAT THE
SETUP PROCESS and press ENTER to repeat the
TV Guide On Screen program guide setup process.
Note: Ifyouskipped either_he CaMe boxo/ VCR setup,
tf_e setup confirmation screen (below)winI/stINCOMPLETE
foranyinformation it hasnotreceived
The TV Guide On Screen system will test the code for tbe
brand of VCR you selected. Do not press any keys on the
TV; remote control, or VCR until testing is done.
2. When code testing is done, if your VCR tuned itself to
channel 09, select YES and press ENTER. Go to
"_nfir*ning your setti_gs" &ext colu_*mo_ this page).
If your VCR did not tune
itself to channel 09 and
you want to test the same
code again, sdect TEST
THIS CODE AGAIN
and press ENTER.
If your VCR did not tune
itself to channel 09 and
you want the TV Guide
On Screen system to searcb for tbe correct code, select NO
and press ENTER. Go to step 3.
2. If you selected YES in st_ 1, tbe following screens appear.
i
Press ENTER to exit theTV Guide On Screen setup.
See "importaot setupsteps, oext page. ]
final
If you are using tbe Quick Connect Guide, go to the next
page to complete tbe assisted setup.
Copyright © 2003 TOSHIBA CORPORATION A_Irights reserved 39