Table of Contents
Advertisement
3
Connections
Antenna
Connect the antenna cable/s to your TV.
rear side of the TV
Power
After unpacking, allow the TV set to reach the ambient room temperature before you
connect the set to the mains. Plug the power cable to the mains socket outlet.
Plug the power cable to the mains socket whilst in 'off' position, and then turn the mains
socket on.
IMPORTANT: The TV set is designed to operate on a 220-240V AC, 50 Hz supply.
4
Switching on the TV
In order to turn the TV on from standby mode:
• Press the Standby button, a numeric button or
Programme +/- button on the remote control
• Press the centre of the control switch inwards,
located at the rear left hand side of the TV
5
Internet connection
You can set up your TV so that it can access the Internet through your local area network (LAN) using a wired
or wireless connection.
Wired
Note: The figures are for representation only
satellite
dish
aerial /
cable TV
External Devices
PLEASE ENSURE BOTH UNITS ARE
SWITCHED OFF BEFORE CONNECTING
Use the proper cable to connect two units together.
To select the desired input source, press the Source
button on the remote control. Or press the switch in
consecutively until the Sources list is displayed.
HDMI connection
rear of TV
Wireless
English - 2 -
wireless
modem/router
Advertisement
Table of Contents
