Viewing The Digital Signal Meter; Checking System Status - Toshiba 57H93 Owner's Manual

Viewing the digitalsignalmeter Checking system status
You can view tbe digital signal meter for ANT 1 and ANT 2
digital TV input sources only.
To view the digital signal meter:
1. Press MENU and open the SETUP menu.
2. Highlight INSTALLATION and press ENTER. (A new set
of INSTALLATION menu icons will appear on-screen, as
shown in step 3 below.)
'il_"ll'alm
Sleep Timer
On/OffTimer
Digital TunerHold ....... Off
Slide Show Interval- .2 Sec
Cot]verger]co
3. Open tbe TERRESTRIAL menu, highlight SIGNAL
METER, and press ENTER.
4. Use the ilr• • buttons to select the antenna input and
digital channel whose signal you want to check.
Note: The&glta/ehannd numbe_hatedIn the &gnu/Me,el
se/eendoesnot correspondto an actual TVchannelnumbe/:
Contaez youl local bmadeadersto obtain tl_eRFchannel
numbers foryour local &g/talstations
iMI
To close the screen and return to the TERRESTRIAL menu:
Highlight OK and press ENTER.
To return to normal viewing:
Press EXIT.
To check the system status:
1. Press MENU and open the SETUP menu.
2. Higblight INSTALLATION and press ENTER. (A new set
of INSTALLATION menu icons will appear on-screen, as
shown in step 3).
3. Open the SYSTEM STATUS menu, highlight SYSTEM
INFORMATION, and then press ENTER.
Sleep Timer
On/Off Timer
Digital Tuner Hold ....... Off
Slide Show Interval...2 See
8o_vergenee
4. Use tbe • • buttons to scroll through tbe menu bar to
check tbe Product Information and Software Version.
Bralld: Toshiba 107
Model: 57H93 ,_u{21 2003 - 16:31:05
IEEE 1394 OUID: 0000391428343803 FW21
To close the screen and return to the TERRESTRIAL menu:
Highlight OK and press ENTER.
To return to normal viewing: Press EXIT.
Restore Factory Defaults
To restore all settings and channels to tbeir factory default
values:
1. Follow steps 1-3 above.
2. Use the • • buttons to scroll through tbe menu bar to
select FACTORY DEFAULTS.
3. The screen below left appears. Enter your PIN code (or
0000 if no PIN code has been set). The screen below right
appears.
To cancel the reset: Highlight NO and press ENTER.
To continue the reset process: Highlight YES and press
ENTER. The TV will turn offautomatically after a few
seconds. After tbe TV turns off, unplug tbe TV power cord
and tben plug it in again to complete tbe restore.
iwlaml
52 Copyright © 2003 TOSHIBA CORPORATION All rights reserved