Volume And Mute Controls Of Audio Receiver; Other Regza-Link ® Functions; Displaying Tv Status Information - Toshiba 40SL412U Easy Setup Manual

VOLUME and MUTE controls of Audio
Receiver
With your TV's remote control, you can adjust or
mute the sound volume of the Audio Receiver.
• adjust the volume level.
• turns off the sound.
Note:
• To use this function:
− Set Speaker Preference to Audio Receiver in
the REGZA-LINK Setup menu.
− Confirm that a connected REGZA-LINK
device (such as DVD player, etc) is selected
for the Audio Receiver input source.
• You can also use this function when the audio
receiver is connected to the TV's DIGITAL
AUDIO OUT terminal (not HDMI connection).
In this case, select a digital audio input mode
on the Audio Receiver.
• These functions depend on the device
connected.
®
Other REGZA-LINK
When the Enable REGZA-LINK and each item in the
REGZA-LINK Setup menu are set to On, the following
functions will be enabled.
Item Description
If a connected HDMI device starts
TV Auto playing video or audio, the TV will
Input Switch automatically switch to the appropriate
HDMI input.
If a REGZA-LINK
TV Auto
Power
on, the TV turns on automatically.
If the TV is turned off the TV will send
Device Auto
a message to turn off all of the REGZA-
Standby
LINK ® devices connected to the TV.
From this item, you can set your audio
output preference to the TV speakers
or the audio receiver speakers. When
this item is set to Audio Receiver,
Speaker
the TV remote can be used to adjust
Preference
or mute the volume of the audio.
This item will be grayed out unless
a REGZA-LINK
receiver is connected.
Chapter 6: Using the TV's features
®
functions
® device is turned
®
compatible audio
Note: When you turn on the Audio Receiver,
change its input source, or adjust the sound
volume, the sound will be output from the audio
receiver's speakers even if TV Speakers has
been selected. Turn the TV off and on again to
output the sound from the TV speakers.
To set the REGZA-LINK
1
From the Setup menu, highlight REGZA-LINK
Setup and press
.
2
Press or to highlight Enable REGZA-LINK.
3
to select On.
Press or
Note: If you select Enable REGZA-LINK Off, the
other items will be grayed out.
4
to highlight the REGZA-LINK Setup
Press or
item you want to use, and press
On or desired mode.
TV Auto Input Switch: On/Off
•
TV Auto Power: On/Off
•
Device Auto Standby: On/Off
•
Speaker Preference: TV Speakers/Audio Receiver
•
5
To save the new settings, highlight Done and press
. To revert to the factory defaults, highlight
Reset and press
.

Displaying TV status information

To display TV status information using
Press on the remote control.
RECALL
The following information will display (if applicable):
Current input (ANT/CABLE, VIDEO, etc.)
•
If ANT/CABLE is the current input, either "CABLE"
•
(for cable TV) or "ANT" (for over-the-air broadcasts).
Channel number (if in ANT/CABLE mode)
•
Digital signal strength indicator (bar graph in lower
•
right corner of box; for ATSC signal only)
Stereo, Mono or SAP audio status (when HDMI input
•
mode, Dolby Digital or PCM)
Video resolution
•
Aspect ratio of incoming video signal (4:3 or 16:9)
•
V-Chip rating status
•
GameTimer (if set)
•
®
Setup:
or to select
:
RECALL
(continued)
49