Tractor Controls - Snapper 2690980 Operator's Manual

Tractor Controls
Drake Peda_
Depressing the brake peda_ applies the tractor
brake.
Cruise Control
This locks the ground speed control in forward.
The cruise control has five lock positions.
Electronic Dashboard
See Electronic Dashboard section.
Fue_ Tank
To remove the cap, turn counterclockwise.
Ground Speed Pedams
The forward ground speed peda_ controls the
tractor's forward ground speed. The reverse
ground speed peda_ controls the tractor's reverse
ground speed.
Headlight Switch
This turns the tractor headlights on and off.
Height-of-Cut Switch
This adjusts the mower cutting height. Press the
switch UP to raise the mowing cutting height
and DOWN to lower the mower cutting height.
The height-of-cut is displayed on the electronic
dashboard.
Parking Drake
This locks the parking brake when the tractor is
stopped. See Parking Brake section.
Power Outlet (12V-DO)
The power outlet is 12V-DC. Accessories must be
rated at 9 amps or less.
Power Take-Off (PTO) Switch
This engages and disengages attachments that
use the PTO. To engage the PTO, pull UP on the
switch. Push DOWN to disengage.
NOTE: The operator must be seated firmly in the
tractor seat for the PTO to function.
Reverse Mowing Option (RMO)
This allows the operator to mow (or use other
PTO driven attachments) whi_etraveling in
reverse. To activate, turn the RMO key after the
PTO is engaged. The L.E.D. light will illuminate,
and the operator can then mow in reverse. Each
time the PTO is engaged, the RMO needs to be
reactivated if desired.
mgnition Switch
The ignition switch starts and stops the engine, it
has three positions: OFF, RUN, and START.
STOP Stops the engine and shuts off the
electrica_ system.
RUN AHows the engine to run and powers the
electrical system.
START Cranks the engine for starting.
NOTE: Never leave the ignition switch in the RUN
position with the engine stopped. This will drain
the battery.
Throttle Contro!
This controls the engine speed. Move the throttle
control FORWARD to increase engine speed and
BACK to decrease engine speed. Always operate
at FULL throttle.
Transmission Remease Lever
This releases the transmission so that the tractor
can be pushed by hand.
13