Snapper 2690980 Operator's Manual page 29

Troubleshooting the Mower
Mower cut is Uneven.
Mower cut is rough
Engine stalls easily with
mower engaged.
Excessive mower vibration.
Engine runs and tractor
drives, but mower wiii not
drive.
LOOKFOR
Lift _inkage not properly
attached or damaged.
Mower not Weveled
properly.
Tractor tires not properly
inflated.
Engine speed too slow.
Ground speed too fast.
Mower has other problem.
Engine speed too slow.
Ground speed to fast.
Dirty or clogged air filter.
Cutting height set too low.
Discharge chute jamming.
Engine not up to
operating temperature.
Starting mower in tall
grass.
Mower has other problem.
PTO not engaged.
See authorized dealer.
REIVIEDY
See authorized dealer.
See Check Tire Pressure section.
Set to full throttle.
Slow down.
See authorized dealer.
Set to full throttle.
Slow down.
See Servicing Air Fimter section.
Cut tall grass at maximum cutting height during first pass.
Cut grass with discharge pointing toward previously cut area.
Run engine for several minutes to warm-up.
Start the mower in a cleared area.
Seeauthorized dealer. =..........
gaPe TO.
En g the
Mower has other problem. 'See authorized
29