Operating The Tractor; General Operating Safety; Slope Operation; Adding Fuel - Snapper STGT2754D Operator's Manual

Operating the Tractor

General Operating Safety

Be sure to read all information in the Safety and
Operation sections before attempting to operate this unit.
Become familiar with all of the controls and how to stop
the unit.

Slope Operation

WARNING
Never operate on slopes greater than 17.6 percent
(10°) which is a rise of 3-1/2 feet (106 cm) vertically in
20 feet (607 cm) horizontally.
When operating on slopes use additional wheel
weights or counterweights. See your dealer to
determine which weights are available and
appropriate for your unit.
Select slow ground speed before driving onto slope.
In addition to front and rear weights, use extra caution
when operating on slopes with rear-mounted grass
catcher.
Mow UP and DOWN the slope, never across the
face, use caution when changing directions and DO
NOT START OR STOP ON SLOPE.

Adding Fuel

To add fuel:
1. Remove the fuel cap (A, Figure 4).
2. Fill the tank. Do not overfill. Leave room in the tank
for fuel expansion. Refer to your engine manual for
specific fuel recommendations.
3. Install and hand tighten the fuel cap.

Starting The Engine

1. While sitting in the operator's seat, fully depress the
brake pedal or set the parking brake.
2. Set the cruise control lever in neutral and make sure
that your feet are not depressing the ground speed
control pedals.
3. Disengage the PTO.
4. Set the throttle to middle position (set throttle to FULL
when starting in cold weather).
5. Turn the key to the RUN position to activate the glow
plugs; the glow plug light in the dashboard display will
light.
6. Wait for the glow plug light to turn off, then turn the
key to START. If the engine does not start immedi-
ately, move the throttle to FULL.
7. After the engine starts, move the engine throttle con-
trol to SLOW. Warm up the engine by running it for at
least a minute.
8. Move the throttle to FULL before engaging the PTO
switch or driving the tractor.
NOTE: In the event of an emergency the engine can be
stopped by simply turning the ignition switch to STOP.
Use this method only in emergency situations. For nor-
mal engine shut down follow the procedure given in
STOPPING THE TRACTOR.
Stopping The Tractor & Engine
14