Wireframe Selection; Selecting Everything - Euphonix R-1 Digital Multitrack Operation Manual

Euphonix Version 3 Supplement to the R-1 Operation Manual
5.2.2

Wireframe Selection

The trackball pointer can select regions of Track time.
1. Click on any empty track area.
2. Hold down the trackball left-button and drag the cursor over the Track Sheet.
A rectangular selection grows from that point.
3. Up or down motion of the dragging cursor adds or removes Tracks from the
selection area. Left or right motion adds and subtracts time.
The resulting selection area will be over a contiguous Track and time range.
4. Add discontinuous Tracks to the selection by clicking on the Track names
while holding down the keyboard Ctrl key.
The selection start and end points will not change when adding new Tracks to the
selection.
If you cannot click on empty track area, hold down the keyboard Alt key and click di-
rectly on a Clip. The wireframe begins on top of the Clip at the time of the cursor location.
5.2.3

Selecting Everything

As documented on page 264 of the main R-1 Operation Manual, press Wave+Se-
lect(Enable)All on the Remote to Select All Tracks. With version 3, Select All Tracks
and Select All Time are also offered in popup menus.
Figure 5-4 Wireframe Selection
47
Editing and Selection Features