Track Edit Popup Menu - Euphonix R-1 Digital Multitrack Operation Manual

Euphonix Version 3 Supplement to the R-1 Operation Manual
if the file name display is too much information (i.e., it can obscure the waveform) it
too can be turned off. The selected Clip and any Clip under the trackball cursor will still
display its name.
To disable the waveform view and/or the file name view on any given Track:
1. Right-click on the Track Name.
The Track Edit popup menu appears.
2. Select Display Waveforms and/or Display File Names.
Each item's state toggles when selected.
3. To globally set the Display Waveforms and/or Display File Names for all
tracks, press the Wave + (Select Enable) Select All keys.
All tracks are highlighted.
4. Right-click over any one of the selected tracks.
Enabling/disabling either display mode affects all tracks.
Zooming
The R-1 allows you to zoom in on the track sheet to display sample-accurate wave-
forms. At level 6 and below (zoom in for lower levels) there may be a pause while the
waveforms calculate. This is due to the large amount of audio data being refreshed di-
rectly from the audio hard drives for each new view. The waveforms at these levels do
not refresh while the Transport is active because it uses all of the system's resources.
When Transport operations cease, the waveforms refresh.
Figure 2-2 Track Edit popup menu
16
Display Features