Table of Contents
Advertisement
Back to Contents Page
Wireless Mini-Card(s)
Alienware® M11x R2 Service Manual
Removing the Mini-Card(s)
Replacing the Mini-Card(s)
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
computer.
NOTE:
Dell or Alienware does not guarantee compatibility or provide support for Mini-Cards from sources other than Dell or Alienware.
If you ordered a wireless Mini-Card with your computer, the card is already installed.
Your computer supports two Mini-Card slots:
One full Mini-Card slot — for WWAN
l
One half Mini-Card slot — for WLAN
l
NOTE:
Depending on the configuration of the computer when it was sold, the Mini-Card slot may or may not have a Mini-Card installed.
Removing the Mini-Card(s)
1. Follow the instructions in
Before You
2. Remove the base cover (see
3. Remove the battery pack (see
4. Disconnect the antenna cables from the Mini-Card.
1 screw 2 antenna cables (2)
3 Mini-Card
5. Remove the screw that secures the Mini-Card to the system board.
6. Lift the Mini-Card out of the connector on the system board.
Begin.
Removing the Base
Cover).
Removing the Battery
Pack).
Removing the Battery
Pack) before working inside the
Advertisement
Table of Contents
