Wireless Mini-Card; Removing The Mini-Card - Dell Inspiron N4020 Service Manual

Back to Contents Page
Wireless Mini-Card
Dell™ Inspiron™ N4020/N4030 Service Manual
Removing the Mini-Card
Replacing the Mini-Card
WARNING:
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
is not covered by your warranty.
CAUTION:
surface (such as a connector on your computer).
CAUTION:
computer.
CAUTION:
in the safety instructions that shipped with your computer).
NOTE: Dell does not guarantee compatibility or provide support for Mini-Cards from sources other than Dell.
If you ordered a wireless Mini-Card with your computer, the card is already installed.
Your computer supports one half Mini-Card slot — Wireless Local Area Network (WLAN), Wi-Fi, or Worldwide Interoperability for Microwave Access (WiMax).
NOTE: Depending on the configuration of the computer when it was sold, the Mini-Card slots may or may not have Mini-Cards installed in them.
Removing the Mini-Card
1. Follow the instructions in
2. Remove the battery (see
3. Follow the instructions from
4. Follow the instructions from
5. Remove the module cover (see
6. Remove the memory module(s) (see
7. Remove the keyboard (see
CAUTION:
tabs; if you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keep
them evenly aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented
and aligned.
8. Disconnect the antenna cables from the Mini-Card.
Great user manuals database on
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
To help prevent damage to the system board, remove the main battery (see
When the Mini-Card is not in the computer, store it in protective antistatic packaging (see "Protecting Against Electrostatic Discharge"
Before You Begin.
Removing the Battery).
step 3 to step 4 in Removing the Hard
step 3 to step 5 in Removing the Optical
Removing the Module
Removing the Memory
Removing the Keyboard).
When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables have connectors with locking
UserManuals.info
Removing the
Drive.
Drive.
Cover).
Module(s)).
Battery) before working inside the