Table of Contents
Advertisement
Back to Contents Page
Display Assembly
Alienware® M11x R2 Service Manual
Removing the Display Assembly
Replacing the Display Assembly
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
computer.
Removing the Display Assembly
1. Follow the instructions in
Before You
2. Remove the base cover (see
3. Remove the battery pack (see
4. Follow the instructions from
5. Remove the memory module(s) (see
6. Disconnect the antenna cables from the Mini-Card(s).
7. Note the routing of the Mini-Card antenna cables and remove them from the routing guides on the computer base.
1
Mini-Card antenna cables
8. Turn the computer over and open the display as far as possible.
9. Remove the hinge cover (see
10. Remove the keyboard (see
11. Remove the palm rest assembly (see
12. Pull the pull-tab to disconnect the display cable from the connector on the system board.
Begin.
Removing the Base
Cover).
Removing the Battery
Pack).
step 4
to
step 6
in
Removing the Hard
Removing the Memory
Module(s)).
Removing the Hinge
Cover).
Removing the
Keyboard).
Removing the Palm Rest
Removing the Battery
Drive.
Assembly).
Pack) before working inside the
Advertisement
Table of Contents
