Table of Contents
Advertisement
2. Align the notch in the memory module with the tab in the memory-module connector.
3. Slide the memory module firmly into the connector at a 45-degree angle, and press the memory module down until it clicks into place. If you do not hear
the click, remove the memory module and reinstall it.
NOTE:
If the memory module is not installed properly, the computer may not boot.
1
memory-module connector
3
notch
4. Replace the battery pack (see
5. Replace the base cover (see
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
6. Turn on the computer.
As the computer boots, it detects the additional memory and automatically updates the system configuration information.
To confirm the amount of memory installed in the computer:
Click Start
® Control Panel® System and Security® System.
Back to Contents Page
2
Replacing the Battery
Pack).
Replacing the Base
Cover).
tab
Advertisement
Table of Contents
