Snmp Community - TP-Link TL-SG2452 User Manual

10.1.5 SNMP Community

SNMP v1 and SNMP v2c adopt community name authentication. The community name can limit
access to the SNMP agent from SNMP network management station, functioning as a password. If
SNMP v1 or SNMP v2c is employed, you can directly configure the SNMP Community on this
page without configuring SNMP Group and User.
Choose the menu SNMP→SNMP Config→SNMP Community to load the following page.
The following entries are displayed on this screen:
Community Config

Community Name:
Access:
MIB View:
Community Table

Select:
Community Name:
Access:
MIB View:
Operation:
Note:
The default MIB View of SNMP Community is viewDefault.
Figure 10-7 SNMP Community
Enter the Community Name here.
Defines the access rights of the community.

read-only: Management right of the Community is
restricted to read-only, and changes cannot be made to
the corresponding View.

read-write: Management right of the Community is
read-write and changes can be made to the corresponding
View.
Select the MIB View for the community to access.
Select the desired entry to delete the corresponding Community. It
is multi-optional.
Displays the Community Name here.
Displays the right of the Community to access the View.
Displays the Views which the Community can access.
Click the Edit button to modify the MIB View and the Access right
of the Community, and then click the Modify button to apply.
102