Connecting; Connecting Front - Yamaha RX-V673 Owner's Manual

Push-type speaker terminals
(RX-V673 only)
(_) Remove approximately 10 mm (3/8") of insulation from
the ends of the speaker cable, and twist the bare wires of
the cable firmly together.
(_) Press down the tab.
(_) Insert the bare wires of the cable into the hole in the
terminal.
(_) Release the tab.
I
+ (red)
- (black)
Connecting the subwoofer
Use an audio pin cable to connect the subwoofer.
Audio pin cable
Connecting front speakers that
support bi-amp connections
When using front speakers that support bi-amp
connections, connect them to the FRONT jacks and
SURROUND BACK/BI-AMP jacks.
To enable the bi-amp function, set "Power Amp Assign"
(p.91) in the "Setup" menu to "5ch BI-AMP" after
connecting the power cable to an AC wall outlet.
The unit (rear)
Caution
• Before making bi-amp connections, remove any brackets or
cables that connect a woofer with a tweeter. Refer to the
instruction manual of the speakers for details. If you are not
making bi-amp connections, make sure that the brackets or
cables are connected before connecting the speaker cables.
• Surround back speakers cannot be used during bi-amp
connections.
PREPARATIONS • Connecting speakers En 21