Weber Summit S-460-NG Owner's Manual page 9

2)Remove the two s crews that secure the control panel to the frame.
3)Remove the control panel.Tilt panel forward and l ift u p and a way from grill. Be careful
not tobreak ordisconnect the wires for t he c ontrol panel lights.
Rest the control panel against the left side o f t he grill (A) e xposing the v alves, burners,
igniter, and m anifold.
CHECK FOR GAS LEAKS
DANGER
Do not use an open flame to check for gas leaks. Be sure
there are no sparks or open flames in the area whiJe you
check for leaks. Sparks or open flames will result in a fire or
explosion which can cause serious bodily injury or death
and damage to property.
WARNING: You should check for gas leaks every time you
disconnect and reconnect a gas fitting.
Note: All factory-made connections have been thoroughly checked for gas leaks. The
burners have been flame-tested. As a safety precaution however, you should recheck all
fittings for leaks before using your Weber gas barbecue. Shipping and handting may
loosen or damage a gas fitting.
WARNING: Perform these leak checks even if your barbecue
was dealer or store assembled.
You will need: a soap and water solution, and a rag or brush to apply it.
Turn on gas supply (A).
Check for leaks by wetting the connections with the soap and water solution and
watching for bubbles. If bubbles form or if a bubble grows, there is a leak.
Note: Since some leak test solutions, including soap and water, may be slightly
corrosive, a!l connections should be rinsed with water after checking for leaks.
WARNING: Do not ignite burners when leak checking.