Weber Summit 43267 Installation Manual
Weber Summit 43267 Installation Manual

Weber Summit 43267 Installation Manual

Built-in lp gas grill

Advertisement

Gas Grill
Built-In LP Gas Grill Installation Guide
s-460
s-660
YoU mUSt rEad thiS ownEr'S gUidE
bEforE oPErating YoUr gaS griLL.
m dangEr
if you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flames.
3. open lid.
4. if odor continues, keep away from the
appliance and immediately call your gas
supplier or your fire department.
Leaking gas may cause a fire or explosion
which can cause serious bodily injury or death,
or damage to property.
m warning:
1. do not store or use gasoline or other
flammable liquids or vapors in the vicinity
of this or any other appliance.
2. an LP cylinder not connected for use shall
not be stored in the vicinity of this or any
other appliance.
tank Enclosure installation - Pg 27
#43267
m warning: follow all leak-check
procedures carefully in this manual prior
to barbecue operation. do this even if the
barbecue was dealer-assembled.
notiCE to inStaLLEr: these instructions
must be left with the owner and the owner
should keep them for future use.
thiS gaS aPPLianCE iS dESignEd for
oUtdoor USE onLY.
m warning: do not try to light this appliance
without reading the "Lighting instructions"
section of this manual.
43267 US 06/11/09
LP
EngLiSh

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Summit 43267 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Weber Summit 43267

  • Page 1 Gas Grill Built-In LP Gas Grill Installation Guide s-460 ™ s-660 ™ YoU mUSt rEad thiS ownEr’S gUidE bEforE oPErating YoUr gaS griLL. m dangEr if you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flames. 3.
  • Page 2: Locating Your Grill

    Combustible materials should never be within 24 (60.96cm) inches of the top, bottom, back or sides of your weber barbecue. m do not put a barbecue cover or anything flammable on, or in the storage area under the barbecue.
  • Page 3 SUmmit ® bUiLt-in SidEbUrnEr inStaLLation/ ownEr’S gUidE before designing your “island” structure. www.wEBEr.COM ® BUilT-in CUTOUT DiMEnsiOns “islanD” sTrUCTUrE COnFiGUraTiOn OPTiOns gas grill, Weber ® ® Summit 4-burner/6-burner grill ® Gas supply Optional sideburner accessory...
  • Page 4: Built-In Cutout Dimensions

    (971.55 mm) Built-In Frame toLEranCES + 1 / 4 " - 1 / 4 " (6.35mm) + 1 / 4 " - 1 / 4 " (6.35mm) + 1 / 4 " - 1 / 4 " (6.35mm) www.wEBEr.COM ®...
  • Page 5: Parts List

    Lid - 1 Cookbox - 1 front frame rail - 1 rear frame rail - 1 rear Panel assembly - 1 bottom Shelf - 1 www.wEBEr.COM ® ParTs lisT Left door - 1 right door - 1 warming rack - 1...
  • Page 6 Screw - 2 Plastic anchors - 5 Keps nuts (1/4 x 20 Keps nut) - 2 1 inch bolt (¼-20 x 1 inch bolt) - 2 handle hardware - 4 wire tie - 1 7/16 inch wrench - 1 www.wEBEr.COM ®...
  • Page 7 ® assEMBlY m attEntion! do not attach rear support screws and washers until Step #6. door Stop bracket (a) should be positioned as shown.
  • Page 8 Clips should slide freely when installed. www.wEBEr.COM ®...
  • Page 9 ®...
  • Page 10 ®...
  • Page 11 CaUtion: Use two people to lift and install the Summit Lift the frame assembly into the “island” structure opening. Make sure the frame is resting level on the finished surface of the structure. Adjust the Front Vent to rest squarely on ground. www.wEBEr.COM ® assEMBlY built-in frame assembly.
  • Page 12: Drill Bit

    4 " (6.35 mm) drill bit S-460™ S-660™ www.wEBEr.COM ®...
  • Page 13 ® assEMBlY Apply a bead of silicone sealant (1) around the perimeter and front edges of the grill that are in contact with the “island” structure. This will prevent moisture seepage. The sealant you use must have a temperature rating above 120°F (48.8°...
  • Page 14 S-460™ assEMBlY BaTTErY hOUsinG wirinG BLACK WIRE GREEN WIRE RED WIRE RED WIRE m warning: make sure that all control knobs are turned to the off position before connecting the gas supply and operating the grill. S-660™ www.wEBEr.COM ®...
  • Page 15 ® assEMBlY Requires 3 “D” alkaline batteries (included). Use alkaline batteries only. Do not mix old and new batteries or different types of batteries (standard, alkaline or rechargeable). note: Secure wire to side panel.
  • Page 16 S-460™ S-660™ www.wEBEr.COM ®...
  • Page 17 S-460™ S-660™ match holder www.wEBEr.COM ®...
  • Page 18 4 " (6.35 mm) drill bit www.wEBEr.COM ®...
  • Page 19 ™ s-660 ™ www.wEBEr.COM ®...
  • Page 20 ™ s-660 ™ s-460™ s-660™ www.wEBEr.COM ®...
  • Page 21 ®...
  • Page 22 ™ s-660 ™ assEMBlY www.wEBEr.COM ®...
  • Page 23 ™ s-660 ™ The Weber Grill Out ™ Handle Light has a “Tilt Sensor”: Lid up - ON / Lid Closed - OFF. The power button (a) activates or deactivates the “Tilt Sensor.” For daytime use, deactivate the sensor by pressing power button (a).
  • Page 24: Gas Supply

    ⁄ ⁄ ⁄ (120.65 mm) (120.65 mm) ⁄ ⁄ ⁄ ⁄ (158.8 mm) (158.8 mm) ⁄ ⁄ ⁄ ⁄ (63.5 mm) (63.5 mm) ⁄ Plan View Left Side View Gas Inlet www.wEBEr.COM (3.8mm) (3.8mm) (3.8mm) (3.8mm) (3.8mm) (3.8mm) ®...
  • Page 25: Test Connections

    Z223.1/NFPA 54, Natural Gas and Propane Installation Code, CSA B149.1, or Propane Storage and Handling Code, B149.2, or the Standard for Recreational Vehicles, ANSI A 119.2/NFPA 1192, and CSA Z240 RV Series, Recreational Vehicle Code, as applicable. www.wEBEr.COM ® Gas sUPPlY...
  • Page 26 20 LP ProPanE gaS SUPPLY inStaLLation The remote tank enclosure kit provided with your Weber Built-In grill shall be used for installations using a 20 lb LP cylinder, mounted in an “island” structure. The remote tank enclosure shall house the included hose and regulator assembly and...
  • Page 27 BUilT-in TanK EnClOsUrE insTrUCTiOns oPErating m warning: only use the weber tank Enclosure Kit outdoors ® in a well-ventilated area. do not use in a garage, building, breezeway or any other enclosed area. m warning: Your weber tank Enclosure Kit shall not be used ®...
  • Page 28 LP tank Enclosure must be built from noncombustible materials only. NOTE: If you have questions on what materials are considered noncombustible, contact you local building supplier or fire department. LP Tank Enclosure Kit in a garage, ® www.wEBEr.COM ®...
  • Page 29: Parts List / Assembly

    ® ParTs lisT / assEMBlY hose and regulator - 1 tank stand - 1 tank stand base - 1 tank Scale - 1 1/4-20 nut - 6 nylon washer - 12 1/4-20 x 1/2” bolt - 6 Cylinder glide - 2 1/2”...
  • Page 30 LP tanK EnCLoSUrE gaS LinE LoCationS Area should be kept clear of sharp, jagged, or extremely abrasive surfaces to avoid possible damage to gas supply lines. Exercise caution when pulling gas lines through built-in structure. ParTs lisT / assEMBlY www.wEBEr.COM ®...
  • Page 31: Connect Gas Supply

    Typical tank cabinet or tank enclosure location Side View Top of Box Back of Box Corrugated Gas Line to Manifold 90° fitting 1/2” (12.7 mm) Flared Gasket Cap (Optional Side Burner) www.wEBEr.COM ® Gas sUPPlY ® Built-In tank Enclosure Kit...
  • Page 32 ©2009 The following trademarks are registered in the name of Weber-Stephen Products Co., an Illinois corporation, located at 200 East Daniels Road, Palatine, Illinois 60067 U.S.A.

This manual is also suitable for:

Summit s-460Summit s-660

Table of Contents