Table of Contents
Advertisement
Be careful
not tobreak or disconnect
the wires for t he control
panel lights.
Rest the control
panel against
the left side o f t he grill (A) e xposing
the v alves,
burners,
igniter,
and m anifold.
8) Remove
the two s crews
that secure
the manifold
to the cookbox.
Pull manifold
assembly
out from t he manifold
frame.
9) Pull the selected
burner(s)
tube(s)
from manifold
frame and replace
with a new
burner
tube.
!iii
ii!ii!ii!ii!ii!ii!ii!ii!ii!iiiii_
i !iiiiii! iiiiiiiiili ! i!i!!!
REMOVING THE SEAR STATION
TM
BURNER
To remove the Sear Station Burner
TM,
pull the burner tube toward you. This removes it
from the burner tube notch (a.). Then rotate the tube clockwise
(b.), taking care to rotate
the burner tube so that the screw at the end of the tube (d.) fits through the notch in the
heat shield opening (e.). When the burner tube is free, remove it from the firebox (c.).
10)
To reinstall the manifold assembly, reverse steps 7 through 9.
Z_ CAUTION:The
burner openings (A) must be positioned
properly over the valve orifices (B).
Make sure the opposite
end of the burner tubes (C) properly
align into the slots on the backside
of the cookbox.
Check
proper assembly
before fastening
manifold
in place.
Z_ WARNING: After reinstalling
the gas lines, they should
be
leak checked with a soap and water solution
before using
the grill. (See, "Check for gas leaks.")
Advertisement
Table of Contents
