Table of Contents
Advertisement
Connections
& Setup
Install Batteries
in the Remote
1.
Remove the battery compartment
cover on the back of the remote.
2.
Insert new batteries. Match the polarities
(+ and -) on the batteries
with the diagram on the remote.
3.
Put the battery compartment
cover back on the remote.
Important
Battery Information
If you're not going to use the remote for a month or more, be sure
to remove the batteries because
they can leak and cause damage.
•
Dispose of batteries in the proper manner, according
to federal,
state, and local regulations.
Any battery may leak electrolyte
if mixed with a different battery
type, if inserted incorrectly,
if all batteries are not replaced
at the
same time, if disposed
of in fire, or if an attempt is made to charge a
battery not intended to be recharged.
•
Discard leaky batteries
immediately.
Leaking batteries can cause skin
burns or other personal
injury.
Point
the Remote
in the
Right
Direction
When you want the remote to operate
the DVD Player, point the remote
at the DVD Player, not the TV. The remote has to be pointed in the
correct direction and toward the correct component
in order for the
remote's
signal to communicate
with the sensor on the component.
Make sure there is a clear path between
the remote and the component
you want to operate
so the signal isn't blocked.
Turn on the TV and DVD Player
1. Turn on your TV and tune to the correct video input channel (see
following page).
2.
Press the DVD button on the DVD remote or the ON,OFF
button on
the DVD player.
Chapter
I
17
Advertisement
Table of Contents
