Table of Contents
Advertisement
Connections
& Setup
Things to Consider
Before You Connect
Protect Against Power Surges
•
Connect all components
before you plug any of their power cords into the wall outlet.
•
Turn off the TV and/or
components
before you connect or disconnect
any cables.
•
Make sure all antennas
and cables are properly grounded.
Refer to the Important
Safeguards
sheet packed with your DVD player.
Protect Components
from Overheating
•
Don't block ventilation
holes on any of the components.
Arrange the components
so that air
can circulate freely.
•
Don't stack components.
•
When you place components
in a stand, make sure you allow adequate
ventilation.
•
If you connect
an audio receiver or amplifier, place it on the top shelf so the heated air from
it won't flow around other components.
Position Cables Properly to Avoid Audio Interference
•
Insert each cable firmly into the designated
jack.
•
If you place components
above the TV, route all cables down the side of the back of the TV
instead of straight down the middle of the back of the TV.
•
If your antenna
uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin
lead cables away from audio/video
cables.
Connection
Pictures
Audio/video
cables are usually bundled
together. For better visibility, the connection
pictures
in
this book show each cable separately
(audio left, audio right, and video).
Types of Discs Your DVD Player will Play
•
DVD video discs - DVD video discs contain high quality picture and sound content.
•
Audio discs - Audio CDs contain musical or sound content only.
Video CD discs - Like DVD video discs, Video CDs contain picture and sound content. The
difference
is the amount of information
that can be stored on the disc.
I_MI'AI. AUDIO
VIDEOCD
6
Chapter
1
Advertisement
Table of Contents
