Assembly - ProForm 790 E User Manual

ASSEMBLY
To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver _z_====_, two adjustable
wrenches _, and a rubber mallet ( _.
_J
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe-
ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The
number following the parentheses is the quantity needed for assembly. Note: If a part is not in the hardware
kit, check to see if it has been preassembled.
M6 Split Washer M8 Split Wave Washer
(111)-12 Washer (83)-11 (95)-2
M8 Locknut
(102)-4
M8 x 25mm
Washer (98)-6
#10 x 12.7mm
Screw (59)-12
M8 x 38mm
Bolt (96)-4
M4 x 16mm
Screw (104)-10
M8 x 56mm Patch
Screw (94)-2
H
M10 x 25mm
Washer (36)-2
M8 x 19mm Patch
Screw (82)-15
M8 x 80mm Patch
Screw (84)-2
M10 x 20mm Patch
Screw (66)-2
5