Trouble-Shooting - ProForm 725 TL User Manual

TROUBLE-SHOOTING
Z0
Most treadmill problems can be solved by following the steps below. Find the symptom that aoolies.
_nd
follow the steps listed.
If further asslstanca is needed, ca!l our toll-free HELPLINE at 1-800-736-6879, Monday through Saturday, 7
e.m. until 7 p.m. Central Time (exclud|ng holidays).
1. SYMPTOM: THE POWER DOES NOT TURN ON
a. Make sure that the power cord Is plugged into a surge protector, and that the surge protector isplugged into
a properly grounded outleL (See HOW TO PLUG IN THE POWER CORD on page9.) Use only a UL-listed
surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length.
b. After the powercord has been plugged in, make sure that the key is fully Inserted Into the console. (See steo
1 on page 11.)
c. Check the circuit breaker located on the treadmill near the
..... power cord. If _e switch protrudes as shown, the circuit
breaker has tripped. To reset the circuit breaker, wait for five
•minutes and then press the switch back in.
c.
Tripped Reset
d. Check the on/off switch located at the front of the treadmill : " " d
near the power cord. The switch must be in the =on"position.
2. SYMPTOM: THE POWER TURNS OFF DURING USE
On 41
Position _l
a. Check the circuit breaker located on-the beadmill frame near the power cord (see 1. c. above). If the circuit
breaker has _pped, walt for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in.
cl Remove the key from the console. Reinsert the key fully into the console. (See step 1 on page 11.)
d. Check to make sure that the on/off switch is in the =on" position. (See 1. d. above.)
e. If the treadmill still will not run, please call our toll-free HELPLINE.
3. SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON
a. Use 0nlya UL-listed surge protector, rated at 15 stops, with a _14_auge cord of five feet or less in length.
b. If the walking belt still slows when walked on, please call our toll-free HELPLINE.
II ,2 u _I_1 ii i# J_
4. SYMPTOM: ._N ERROR CODE ( E2, E3, E4, OR E5 ) APPEARS ON THE CONSOLE
a. Error code "E2" may appear in the SPEED display if the SPEED increase or START4PAUSE button is
pressed and no movement of the Walking belt is detected within seven seconds. Rernove the key, wait for
ten seconds, and then reinsert it. Make sure that you stand on the foot roils of the treadmill each time you
start the walking belt. If the error code appears again, call our toll-froe Customer Service Department. Do not
operate the treadmill until the problem is corrected.
b. Error code "E3" may appear in the SPEED display if the speed of the walking belt surges above the se-
lected speed setting. Remove the key, wait for ten seconds, and then reinsert it. It the error code appears
again, call our toll-free Customer Service Department. Do not operate the treadmill until the problem is cor-
rected.