How To Fold And Move The Treadmill - ProForm 725 TL User Manual

HOW TO FOLD AND MOVE THE TREADMILL
HOW TO FOLD THE TREADMILL FOR STORAGE
Before folding the treadmill, adjust the incline to the lowest
•position. If the incline Is not at the lowest position, the
traadmlll will be permanently damaged. Next, unplug the
• power cord. Caut!on: You must be ab!e to safely lift 45 :
pounds (20 kg) in order to raise, lower, or move the
treadmlU.
1. Hold the treadmill with y'odPI_ands in the locations shown
at the dghL caution.; To avoid pinchlng your hands, do
not hold the treadmill In the locations Indicated by the
arrows. To decrease the possibility of Injury, bend
your legs and keepyour back straight. As you raise
the treadmill, make stJre to lift with your legs ratl_er
"than your back. Raise the treadmill about halfway to the
vertical position.
2. Move your right hand tO the position shown and hold the
treadmill firmly. Raise the treadmill until the storage latch
• closes over the frame guide. Make sure that the storage
latch closes fully over the frame guide.
To protect the floor or carpet from damage, place a
mat under the treadmill. Keep the treadmill out of di-
rect sunlight. Do not leave the treadmill In the storage
position in temperatures above 85 ° Fahrenheit.
Do not hold here ,
THE WOODGRAIN-FINISH COVER PANEL
When the treadmillis in the storage position, the woodgrain-
finish cover panel will accent the decor of your room. If
desired, you can remove the cover panel to display the
black-finish frame cover instead. To remove the cover panel,
simply insert your fingers between the lower end of the cover
panel and the frame cover (see the arrow at the right) . Pull
the cover panel off the panel fasteners, working your way up
until the cover panel is removed.
Cover Panel
18
After the cover panel is removed, the panel fasteners can be
i'emoved for a cleaner al_pearance. Using a phillips head
screwdriver, remove one-bfthe Panel screws and panel
fasteners from the frame cover. Tighten the panel screw
back into the frame cover. Repeat this process, removing
one panel fastener at a time, until all six panel fasteners
are removed• Press the removed panel fasteners onto the
fasteners on the back of the cover panel. Store the cover
panel away from moisture and dust.
Cover_
_eWX, pa_Panel Screw /
_ Fastener
Fastener