Extron electronics TPS150 User Manual page 3

Quick Start — TPS150 Switching
and Transmission System
Installation
Step 1
Turn off power to the input and output devices,
and remove the power cords from them.
Step 2
If desired, mount the TPT150 transmitter in a
rack.
Step 3
If desired, mount the TPR150 receiver using the
included projector bracket.
Step 4
Connect source video devices to the transmitter's
inputs.
Inputs 1 and 2 — Connect
two RGB video sources.
If desired, connect a
monitor to the Input 1 Local Monitor
connector.
Inputs 3 and 4 —
Connect either
component video,
S-VIDEO
S-video, or
composite video
sources.
For proper
system operation, connect only one video
format to input 3 and input 4.
Step 5
Connect audio devices to the input 1
through input 4 left and right RCA
connectors.
Step 6
Connect an audio device, such as powered
speakers, to this 3.8 mm, 5-pole captive screw
connector for balanced or unbalanced audio
output.
Tip
CAUTION
See caution
Sleeve
Tip
See caution
Unbalanced Output
Tip
Ring
Sleeve (s)
Tip
Ring
Balanced Output
Step 7
Connect a host device, such as a computer or
touch panel control, to the transmitter via this
9-pin D connector and a null modem serial
port cable for serial RS-232 control.
5
Step 8
Connect an optional CTP150CM
control panel module or other
contact closure device to this 8-pin
3.5 mm captive screw connector.
See chapter 2, Installation.
VIDEO R-Y
To make your own contact closure
device, wire the connector as
shown at right. To issue a
command, momentarily short the
appropriate pin to ground.
Y B-Y
Step 9
Connect a shielded twisted pair (STP) cable or
foil shielded pair (FTP) with RJ-45 connectors
between the transmitter and receiver. Ensure
that both ends of the cable are terminated using
L
the same protocol, either TIA/EIA 568 A or 568 B.
R
Connect the
sleeve to ground.
Connecting the
sleeve to a
negative (-)
terminal will
damage the audio
output circuits.
TPS150 Switching and Transmission System • Quick Start
Connected
TPS150 RS-232
pin device pin Function
1
1 —
2 RX
3 TX
9 6
4 —
Female
5 Gnd
6 —
7 —
8 —
9 —
Extron recommends STP or FTP cable
only.
Side Clip Down
RJ-45
connector
Pin
1 White-green
2 Green
3 White-orange
4 Blue
5 White-blue
1 2 3 4 5 6 7 8
6 Orange
7 White-brown
8 Brown
1&2 7&8
3&6 4&5
Not used
Receive data
Transmit data
Not used
Signal ground
Not used
Not used
Not used
Not used
CONTACT
CLOSURE
GND
PROJ PWR
VOL DN
VOL UP
IN4
IN3
IN2
IN1
568 A 568 B
Wire color Wire color
White-orange
Orange
White-green
Blue
White-blue
Green
White-brown
Brown
Twisted
Pairs
QS-1