Extron electronics VersaTools MTP DA4 User Manual page 3

Quick Start Guide
VersaTools ® MTP DA4 and MTP DA8
Install and set up the MTP DA as follows:
Step 1
Turn all of the equipment off and disconnect it from the power
source.
Step 2
If the DA is part of a system that includes an MTP T 15HD A or
MTP 15HD RS transmitter, check, and if necessary, reconfigure the
serial data/audio termination and mute jumpers inside the DA. See
Termination and Mute Jumpering — MTP 15HD Systems Only, on page 4.
Step 3
Connect a twisted pair (TP) cable from an MTP
transmitter, MTP SW switcher, or VTT
transmitter to the A/V Input RJ-45 connector.
See the TP connector table at right to terminate
the cable.
Step 4
Connect up to 4 or 8 TP cables between the
DA's A/V Outputs connectors and an MTP or
VTT receiver that is compatible with the
transmitted signal. See the TP connector table
at right to terminate the cable.
Step 5
If desired, connect a contact closure control to the Output Mute
captive screw connector shown below. Each numbered pin is
assigned to a DA output (pin A is assigned to all DA outputs). When
you short and latch a pin or pins to ground, the DA mutes the
associated twisted pair output(s).
Pin
MTP DA8
Output Mute Connector
1 2 3 4 5 6 7 8 A
MTP DA4
Output Mute Connector
1 2 3 4 A
VersaTools ® MTP DA4 and MTP DA8 • Quick Start Guide
TIA/EIA 568 A
TP connector
Pin Wire color
1 White-green
2 Green
3 White-orange
4 Blue
5 White-blue
6 Orange
7 White-brown
8 Brown
CC Function
1 Out #1 Mute output #1
2 Out #2 Mute output #2
3 Out #3 Mute output #3
4 Out #4 Mute output #4
5 Out #5 Mute output #5
6 Out #6 Mute output #6
7 Out #7 Mute output #7
8 Out #8 Mute output #8
A Out All Mute all
Gnd Ground
QS-1