Craftsman 675 Series Operator's Manual page 18

Problem Cause Remedy
Engine fails
to start
I
1. Sparkplug wire disconnected• I 1. Connectwireto sparkplug.
2 Fueltank erupt or stale fuel 2 F tank wth c ean,fresh gaso ne
• y . ,
3. Chokelevernotin CHOKEposition• 3. Movechoketo CHOKEposition•
4 Fault sparkplug 4 Servicesparkplug following
• y • •
instructionsin the maintenance
section
5 Bockedfue ne
• 5. Cleanfuel line.
6. Serviceair cleanerfollowing
I 6. D_rty air cleaner• instructionsin the maintenance
section•
Engine runs erratic
1. Unit runningwith CHOKEapplied,if sc 1. Movechoke leverto RUNposition.
equipped.
2. Sparkplug wireloose. 2. Connectand tightenspark
plug wire.
3. Blockedfuel line or stale fuel. 3. Cleanfuel line;fill tank with clean,
fresh (less than30 daysold)
gasoline.
4. Water or dirt in fuel system. 4. Drainfuel tank.Refill with
fresh fuel.
5. Dirtyair cleaner. 5. Cleanor replaceair cleaner.
6. Carburetornotadjustedproperly. 6. ContactSearsservicecenter.
EngineOverheats
1. Engineoil levellow. 1• Fill crankcase with prope_ oil.
2. Dirty air cleaner 2. Serviceair cleanerfollowing
instructionsin the maintenance
I secton
3. Carburetornotadjustedproperly.
' ' 3. ContactSearsservicecenter•
Cylinder rod will not
1. Brokendriveshaft. 1. Returnunit to Searsservicecenter.
move 2. Shippingplugsleft in hydraulichoses.
3. Setscrews in couplingnot adjusted
properly.
4. Looseshaftcoupling.
5. Gearsectionsdamaged.
6. Damagedreliefvalve.
7. Hydrauliclinesblocked.
8. Incorrectoil level.
9. Damagedor blockeddirectionalvalve.
2. Disconnecthydraulichoses,
removeshippingplugs,reconnect
hoses.
3. See operator'smanualfor correct
adjustment.
4. Correctengine/pump alignmentas
necessary.
5. Returnunit to Searsservicecenter.
6. Returnunit to Searsservicecenter.
7. Flush andclean hydraulicsystem.
8. Checkoil level.Refillif necessary.
9. Returnunit to Searsservicecenter.
NOTE: This section addresses minor service issues. For further details, contact Sears service information line by calling
1-800-4oMY-HOME.
18