Removing The Drive Panel - Dell Precision 490 Desktop User Manual

1 power cable 3 SATA_2 connector
2 SATA data cable 4 optional third SATA hard drive in hard-drive carrier
13. Connect the data cable to the back of the drive and to the connector on the system board.
14. Ensure that all connectors are properly cabled and firmly seated.
15. Reinstall the drive panel (see
16. Replace the computer cover (see
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
17. Connect the computer and devices to electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
18. If the drive you just installed is the primary drive, insert bootable media into drive A.
19. Turn on the computer.
20. Enter the system setup program (see
21. Exit system setup, and reboot the computer.
22. Partition and logically format your drive before you proceed to the next step.
23. See the documentation for your operating system for instructions.
Drive Panels
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.

Removing the Drive Panel

1. Follow the procedures in Before You
2. Remove the front panel (see
Replacing the Drive Panel).
Replacing the Computer Cover).
System Setup) and update the appropriate Drive option.
Begin.
Removing the Front Panel).