Your computer is heavy (it has an approximate minimum weight of 55 lbs) and can be difficult to maneuver. Seek assistance before
attempting to lift, move, or tilt it; this computer requires a two-man lift. Always lift correctly to avoid injury; avoid bending over while lifting. See
your Product Information Guide for other important safety information.
CAUTION:
The computer stand should be installed at all times to ensure maximum system stability. Failure to install the stand could result in the
computer tipping over, potentially resulting in bodily injury or damage to the computer.
2. Remove the computer cover (see
3. Grasp the sliding plate lever and push it towards the base of the computer until the drive panel snaps open.
1 sliding-plate lever
2 sliding-plate
3 drive panel
4 drive-panel tabs
4. Pivot the drive panel outward and lift it from its side hinges.
5. Set the drive panel aside in a secure location.
Removing a Drive-Panel Insert
NOTICE:
Drive-panel inserts may contain screws on the inside. You can attach the screws to new drives that do not have any screws.
1. Remove the drive panel (see
NOTICE:
To avoid breaking the drive-panel insert tab, do not pull the insert more than approximately 1 cm (½ inch) away from the drive panel before
sliding the tab out of the slot.
2. Pinch the drive-panel insert release tabs and rotate the insert just enough to free the release tabs.