Mitsubishi CS-35707 Owner's g Manual page 45

Using the remote control to operate VCRs, cable
boxes and other components (cont.)
setting up the remote control to operate your Mitsubishi
audio component (laserdisc player or A/V receiver)
O Turn off your audio component.
O Set the select switch on the top of the remote to choose the
layer you want to set up. For a laser disc player, choose CABLE
or VCR-B. For an A/V receiver or CD player, choose CABLE.
O
While holding in the POWER button on tile remote control,
enter one of these code numbers:
• For a Mitsubishi A/V receiver, compact disc: 30, 31 or 35
• For a Mitsubishi laserdisc player: 32 or 33
• For a Yamaha A/V receiver, compact disc: 36 or 37
Be sure to enter both digits of the code number. If more than
one number is listed, start with the first one.
O Release the POWER button.
O
Press the POWER button again. Your audio component should
turn on. If it does, your remote control is now set to operate
your audio component. If it does not turn on, repeat the instruc-
tions above, trying the other ,code number listed for your
component.
using your remote control to operate your Mitsubishi
laserdisc player
After you set up your remote control for your laserdisc player, you
can use the remote to operate the player.
{]} Use the select switch on the top of the remote to choose the
layer that you set up to operate your laserdisc player: C2_J3LE
or VCR-B.
Point the remote control at the laserdisc player and press the
desired buttons.
You can use the POWER, numbers (0-9), INFO, MENU,
CANCEL, STOP, PAUSE, REW, PLAY, and FF buttons to
operate your laserdisc player.
46 Chapter 3: Operating Your TV