Table of Contents
Advertisement
TV + VCR
+ antenna
or cable
without
a
cable
box
(cont.)
_>Important:
_>Important:
Important:
procedure
(Please
see illustration
on the following
page.)
O
Connect
the incoming
cable or antenna
to the ANTENNA
IN
terminal
on the VCR.
O
Connect
one end of a coaxial cable to the ANTENNA
OUT
terminal
on the VCR.
Connect
the other end of the coaxial cable 1;othe ANT-A
terminal
on the TV.
O
Do ONE (not both) of the following:
• Connect
a video cable to the VIDEO OUT _erminal
on tile
back of the VCR. Connect
the other end of this cable to the
VIDEO INPUT
terminal
on the back of the television.
• Connect
an S-video cable to tim S-VIDEO
OUT terminal[
on
the VCR. Connect
the other
end of this cable to the
S-VIDEO
INPUT
terminal
on the back of the television.
Connect
audio cables to the AUDIO OUT terminals
on the back
of the VCR. Use the red cable to connect
the right (R) channel
and the white cable to connect the left (L) channel.
Connect
the other
ends of these cables to the AUDIO INPUT
terminals
on the back of the television.
If your VCR is monaural
(non-stereo),
only connect a single audio
cable. Connect
this cable to the AUDIO OUT terminal
on the VCR,
then connect the other end of the cable to the L (LEFT)
audio input
on the back of the television.
If your VCR has a video channel
switch with an "OFF" setting
or
an "AV" setting,
set the switch to that setting.
O
O
Begin playing
a tape of the VCR.
Use the INPUT
button
on the control
panel or on the remote
control to select the input
(INPUT-1
or INPUT-2)
to which you
connected
the VCR.
If you are using the AV network
with your Mitsubishi
VCR, you
must
connect the VCR to INPUT-1.
Basic Connections
31
Hide quick links:
Advertisement
Table of Contents
