Maytag EPIC Z MGD9800TK0 Use & Care Manual page 16

3. Remove the2screws that h old thehandle b racket tothedoor. scratch the dryer s urface. Liftup.Repeat inthemiddle a nd atthe bottom. Remove the
plug strip inthedoor o pening and insert intheopposite side.
4. Move hinge tothe other side and reat_ach withthe4screws removed inStep 2 .
5. Move handle b racket tothe other s ide andreattach withthe 2 screws removed inStep 3 .
6. Set t heinner d oor a ssembly aside.
Reinstalling
the door
1. Check for fingerprints on the glass. Clean if necessary.
2. Place the inner door assembly into the outer door assembly. Align the hinge in the
opening on the side. To fit correctly, the inside door assembly edge is completely inside
the outside door assembly edge.
3. Reassemble the inner and outer door assemblies with the 6 screws.
Style 2: Remove the label.
• Peel off the label located on the opposite side of the door opening covering the hinge
mounting holes. Apply the label over the original hinge holes.
6.
Insert a screw in the second opening from the top of the hinge opening and partially
tighten. Hang the door by placing the top hinge keyhole over the second screw head and
tighten the screw. By putting this screw in first, the door will hang in place while you
insert and tighten the remaining 4 screws.
4.
5.
Replace the 2 handle screws for the door handle of the door assembly.
Remove the plug strip or labeh
Style 1 : Remove the plug strip.
• Use a small flat-blade screwdriver to remove the plug strip in the door opening. Slide
the head of the screwdriver under the top portion of the plug strip, being certain not to
A. Dryer door
B. Dryer
C. Insert this screw first.
7. Close the door and check that it latches securely.
16