Changing; Modifiers; Use - Maytag MTW6400TQ0 Use & Care Manual

3. Addcolor-safe bleach ( powdered orliquid) t othe detergent dispenser, if needed. Be sure
tomatch p owdered color-safe bleach w ithpowdered detergent ormatch l iquid color-safe
bleach w ithliquid detergent.
4. Pour measured liquid chlorine bleach i nto theliquid chlorine bleach d ispenser, if needed.
Bleach i sautomatically dispensed attheproper time during the wash c ycle.
5.
Do not overfill. Do not dilute. Do not use more than I cup (250 m[) for a full load.
Use less with a smaller load size.
Follow the garment and the chlorine [)leach manufacturer's directions for proper use.
lb avoid spilling, use a cup with a pouring spout. Do not let [)leach splash, drip, or run
down into the washer basket.
At the end of the cycle, a small amount of water may be left in the dispenser. This is
normal.
NOTE: Use only liquid chlorine bleach in this dispenser.
Pour measured liquid fabric softener into the fabric softener dispenser, if desired.
IMPORTANT: Dilute all fabric softener with water for a total of 1/2cup (1 18 m[).
•
Do not overfill. The dispenser holds 1/2cup (118 ml.),
• Do not spill or drip any fabric softener onto the clothes.
NOTES:
•
Use only liquid fabric softener ill this dispenser,
• Do not use fabric softener dispensing balls in this washer. Dispensing balls will not
operate correctly with this washer.
6. Close the washer lid.
7. Press POWER. This turns on the washer display.
8. Select a Wash Cycle. See "Cycles."
9. Adjust the Modifiers, if desired. See "Modifiers."
10. Select desired Options. See "Options."
11. On some models, select Delay Wash, if desired. See "Delay Wash" in the "Modifiers"
section.
12. Press STARE The wash cycle begins, and the display shows the estimated remaining time.
The lid will lock.
NOTE: If you do not press Start within 5 minutes of pressing Power, the washer
automatically shuts off.
Add a Garment
You can place additional clothing in the wash when the "Add a Garment" status light is
glowing without sacrificing wash performance.
To add a garment or pause the washer at any time
1. Press PAUSE/CANCEl. once.
2. Wait until the I.id lock light turns off, then open the lid.
3. Add items.
To restart the washer
1. Close the lid and press START.
2. [b unlock the lid after the Add a Garment period, press PAUSE/CANCEl. once. Pressing
PAUSE/CANCEl twice will cancel the wash cycle.
You can stop the wash cycle and drain the tub by pressing the Pause/Cancel button twice or
the Power button once.
You can change Cycles, Modifiers and Options anytime before Start is pressed. Not all
Modifiers and Options are available for all cycles.
• A short tone sounds when a change is selected.
• Three short tones sound if an unavailable combination is selected. The last selection will
not be accepted.
Changing Cycles after pressing Start
1. Press PAUSE/CANCEl. twice to cancel the cycle. Ihe washer will drain.
2. Press POWER.
3. Select the desired wash cycle.
4. Select the desired Modifiers and Options.
5. Press START.
The washer restarts at the beginning of the new cycle.
NOTE: [f you do not press Start within 5 minutes of pausing the washer, the washer
automatically shuts off.
Changing Modifiers and Options after pressing Start
You can change a Modifier or Option anytime before the selected Modifier or Option begins
by choosing the desired Modifiers and/or Options.
NOTE: An error tone will sound if your selection is unavailable.
14