Maytag 23-11-2200N-002 User Manual page 5

Operation°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°
Electmnfc Central Ranel
Tile pictured control panel is similar to your panel.
• Check Filter
Set Temperature/
Timer DisjJlay
_ Temperatur_VTimer
Hour Controls
-- Timer Control
Mode Control
The Mode Control has three settings: Fan, Cool and
Energy Saver. A green light will indicate which mode is
currently being utilized.
Cool Mode - The unit will circulate and cool the air.
Fan Mode - The unit will only circulate the air.
Energy Saver Mode - The fan will switch from the set
fan speed to LO whenever the compressor turns off in
response to the thermostat. When the compressor cycles
back on, the unit will return to the original fan setting.
Check Filter
Light/Reset
Fan Speed
Control
-- Mode Control
Power Control
Fan Speed Control
The Fan Speed Control has four settings: High,
Medium, Low and Auto. The settings are adjusted with the
Fan Speed Control, each time the button is depressed it
changes the setting. A green light will indicate which set-
ting is currently being used.
When the Auto feature is selected while the air condition-
er is in the COOL mode, the fan speeds will change auto-
matically as the temperature in the room changes.
• 7 ° or more above the set temperature will use HI fan.
• 4 ° - 7 ° above the set temperature will use IVIED fan.
• 4 ° or less above the set temperature will use LO fan.
Timer Control
The timer can be set to either turn the unit on or off.
Power Control
The Power Control turns the unit on and off.
Set Temperature/Timer Display
Shows the set temperature when the unit is in operation
and hours when the timer is being set. THE TEMPERA-
TURE DISPLAY ONLY SHOWS THE SET TEMPERATURE,
NOT THE ACTUAL ROOM TEMPERATURE.
Temperature/Timer Hour Controls
These buttons are used to raise or lower the set tempera-
ture in increments of 1 ° from 66 ° to 88 °. By depressing
both buttons at once, the display will toggle between
Celsius and Fahrenheit. When the timer is being set, these
buttons are used to change the hour setting in increments
of 1 from 00 to 24.
Check Filter Light/Reset
After 250 hours of usage the Check Filter light will turn
on. At this time, the filter needs to be removed and
cleaned (see page S). After the filter is cleaned and reposi-
tioned, depress the Reset button. This will restart the
counter and turn the light off.
To turn the unit ON using theTimer:
• Depress
the timer key when the power is off, the
display will read 00. Adjust to the desired number of
hours before TURN ON using the up/down arrows.
• The display will show the time by hours left
until TURN ON.
• To turn the timer off, depress the timer key.
• A green light next to the Timer Control indicates that
the timer is set.
To turn the unit OFF using theTimer.
• Depress the timer key when the power is on, the display
will read 00. Adjust to the desired number of hours
before TURN OFF using the up/down arrows. The display
will automatically go back to the set temperature after 10
seconds.
• To display the amount of time left until TURN OFF,
depress the timer button once.
• To turn the TIMER OFF, depress the timer button twice.
• A green light next to the Timer Control indicates that
the timer is set.
Built-in three minute timing delay.
This electronic controlled unit will not automatically
resume operation after a power failure.
ff this electric unit will not respond to touch pad or
remote control commands, it is necessary to unplug the
unit from the electrical outlet for five seconds and then
plug the unit back in.plug the unit back in
4