Table of Contents
Advertisement
i •
Real T ime Counter Memory 39
Real Time
Counter
Memory
Follow the steps below to reset the real time counter to zero at a
tape location you want to refer to later.
I
Play, fast forward, or rewind a tape to the location that
you would like to refer to later. Press the STOP button on
the remote
control or the STOP/EJECT button on the
VCR to stop the tape.
2
Press the STATUS/EXIT
button. The status display will appear
on-screen for about five seconds.
I :23:45
HIFIJ
3
While the status display is still on-screen, press the CLEAR
but-
ton to reset the real time counter to zero.
/'_oP
_,._P
o:oo:oo
..F.j
4
While the counter is still on-screen, press the MEMORY
but-
ton to set the real time counter memory. M will appear to the left
of the real time counter on-screen.
I
2
3
_OP
I._)8 PH_
SIP
H
0:00:00
HIFIJ
5
To go to a tape location
where
the real time
counter
was
reset to zero, press the REW(ind)
button
or the F.FWD
(Fast Forward)
button
when tape playback
is stopped.
When the tape reaches the point at which the real time counter
was reset to zero, the tape will stop. Press the PLAY button
to
watch the tape.
• The MEMORY button does not func-
tion if Repeat Play is set to ON.To
turn Repeat Play OFF,see Helpful
Hints on page 3 7.
• Toerase a RealTime Counter
Memory, press the MEMORY button
until the M disappears from .the
screen.
• Youmay only set the real time
counter to zero at one location at a
time. If you try to set the real time
counter to zero at a second location,
the previous real time counter to zero
setting will be erased.
Advertisement
Table of Contents
