LIFESTYLER 3500ps Owner's Manual page 11

TREADMILL BELT ADJUSTMENT
The treadmill belt should always be kept centered on the walking platform. If the belt shifts to the right
or left sides of the platform, the belt may be damaged by the roller guard screws. The belt can be
adjusted using the rear roller adjustment bolts a.nd the allen wrench included. CAUTION: ALWAYS
TURN THE POWER OFF BEFORE ADJUSTING THE TREADMILL BELT.
IF THE TREADMILL BELT HAS SHIFTED TO THE LEFT:
TURN THE POWER OFF. Turn the left adjustment bolt
clockwise, and the right adjustment bolt counterclockwise,
1/4 of a turn each. Turn the power on. Repeat as
necessary until the belt is centered.
IF THE TREADMILL BELT HAS SHIFTED TO THE RIGHT:
TURN THE POWER OFF. Turn the left adjustment bolt
counterclockwise, and the right adjustment bolt clockwise,
1/4 of a turn each. Turn the power on. Repeat as
necessary until the belt is centered.
IF THE TREADMILL BELT SLIPS DURING USE: TURN
THE POWER OFF. Turn both adjustment bolts clockwise
1/4 of a turn. Turn the power on. Repeat as necessary
until the belt does not slip. Be careful not to overtighten the
bolts. Overtightening can stretch the belt, cause excessive
roller noise, and reduce motor performance.
To check the treadmill belt for proper tension, TURN THE
POWER OFF, and lift the edges of the treadmill belt. You
should be able to lifteach edge 2-3 inches off the walking
platform. The center of the belt should remain just at the
surface of the platform.
The allen wrench can be stored conveniently on the self-
adhesive wrench clip.
Roller Bracket
(_ Wrench Clip
ROLLER GUARD ADJUSTMENT
The rear edge of the roller guards should be 1/8 inch from
touching the rear roller. To adjust the roller guards, loosen
the screws in the roller guards, slide the roller guards
forward or backward, and retighten the screws.
Roller Guard-......_
Rear Roller "--------
11