Advertisement
b. tf the walking belt has shifted to the right, first remove the safety
key and UNPLUG THE POWER CORD. Using the 3/16" allen
wrench, turn the left rear roller adjustment bolt counterclockwise,
and the right bolt clockwise, 1/4 of a turn each. Be careful not to
overtighten the walking belt. Plug in the power cord, insert the
safety key and run the treadmill for a few minutes. Repeat until
the walking belt is centered.
c. If the walking belt slips when walked on, first remove the safety
key and UNPLUG THE POWER CORD. Using the 3/16" allen
wrench, turn both rear roller adjustment bolts clockwise, 114 of a
turn. When the walking belt is correctly tightened, you should be
able to lift each side of the walking belt 3-4 inches off the walking
platform. The center of the walking belt should just touch the
walking platform. Be careful to keep the walking belt centered. Plug
in the power cord, insert the safety key and run the treadmill for a
few minutes. Repeat until the walking belt is properly tightened.
STORAGE
Unplug the power cord when the treadmUl is not in use.
Remove the left handrail cap and the two bolts from the lower end of
the left handrail (see drawing 1).
Using the 7/32" allen wrench, remove the bolt from the upper end of
the left handrail (see drawing 2). Slide the handrail out and lay it on
the treadmill.
Remove the dght handrail cap and the bolt from the lower end of the
dght handrail. Loosen the other bolt in the handrail (see drawing 3).
Lay the dght handrail on the treadmill.
It is recommended that the treadmill be covered dudng extended peri-
ods of storage.
Remove
11
Advertisement
