Maintenance And Trouble-Shooting - LIFESTYLER DT 450 User Manual

MAINTENANCE AND TROUBLE-SHOOTING
Inspect and tighten all parts of the exercise cycle reg-
ulady. Replace any worn parts immediately.
The exercise cycle can be cleaned with a soft, damp
cloth. Avoid spilling liquid on the console. Keep the
console out of direct sunlight or the display may be
damaged. Remove the batteries when storing the
exercise cycle.
BATTERY REPLACEMENT
If the console does not function properly, the batteries
should be replaced. See assembly step 4 on page 5.
In addition, make sure that the reed switch wire is
plugged fully into the console.
HOW TO TIGHTEN THE CRANK
If the arms of
the crank
become
loose, they
should be
tightened in
order to pre-
vent exces-
sive wear.
Loosen the
crank nut on
the left arm of
the crank.
__Slotted
Cran_ Crank
Nut_
Crank Arm
Place the end of a standard screwddver in one of the
slots in the slotted crank nut. Lightly tap the screw-
ddver with a hammer to turn the slotted crank nut
counterclockwise until the arms are no longer loose.
Do not overtighten the slotted crank nut. When the
slotted crank nut is propedy tightened, retighten the
crank nut.
HOW TO ADJusT THE RESISTANCE STRAP
If there is not
enough pedal-
ing resistance Slotted
when the Tab
resistance Resistance
knob is turned
to the highest
setting, the
resistance
strap may
need to be
adjusted. To adjust the resistance strap, first turn the
resistance knob counterclockwise to the lowest set-
ting. Next, locate the slotted tab on the front of the
exercise cycle. Gdp the longest part the resistance
strap undemeath the slotted tab and pull It towards
the slot. When a little slack is created, pull the end of
the resistance strap tight. Tum the crank for a
moment to make sure that there is not too much
resistance.
HOW TO ADJUST THE CHAIN
The exercise cycle features a chain that must be kept
properly adjusted. If the chain causes excessive noise
or slips as you pedal, the chain should be adjusted.
To tighten the
chain, loosen,
but do not
remove, the
axle nuts on
both sides of
the flywheel.
Pull the fly-
wheel forward Nut
slightly. Make
sure that the
flywheel is
straight and retighten the axle nuts.
8