LIFESTYLER DT 450 User Manual page 5

4. The Console (7) requires two "AA" batteries (includ-
ed); alkaline replacement batteries are recommend-
ed. Refer to the inset drawing. Remove the battery
door from the back of the Console and insert two
baftedes into the Console. Make sure that the neg-
ative ends of the batteries (marked "-") are
touching the springs in the Console. Re-attach
the battery door.
Next, plug the Reed Switch Wire (28) fully into the
socket on the back of the Console (7).
Slide the Console onto the console plate. Note: The
Console is held by friction; it does not snap into
place.
5. Press the Frame Bushing (4) into the Frame (1).
(Note: The Frame Bushing may be pre-assembled.)
Next, insert the Seat Post (10) into the Frame.
Align one of the holes in the Seat Post (10) with the
hole in the Frame (1). Insert the Seat Pin (31) into
the Frame and the Seat Post. Make sure that the
Seat Pin Is Inserted into one of the holes in the
Seat Post; do not insert the Seat Pin under the
Seat Post. Tighten the Seat Pin into the Frame.
Slide the Seat (11) onto the Seat Post (10) so that
the Seat Post is inserted as far as possible into the
hole shown in the inset drawing. Straighten the Seat
and tighten the two indicated nuts.
6. Identify the Right Pedal (22), which is marked with
an =R." Remove only the Right Pedal Nut (47) and
the Pedal Bushing (46) from the Pedal. Next, insert
the shaft of the Pedal into the right Pedal Arm (49).
Slide the Pedal Bushing back onto the Pedal, and
position the Pedal Bushing so that it slides into the
Pedal Arm. Tighten the shaft of the Pedal clockwise
into the right arm of the Crank (20) as firmly as pos-
sible. Tighten the Pedal Nut clockwise onto the
Pedal. Make sure that the Pedal and the Pedal
Nut are tightened as firmly as possible.
Repeat this step to attach the Left Pedal (not
shown), turning the Pedal and the Left Pedal Nut
(not shown) counterclockwise.
, \
Console
Plate
/
5
'-_28
Batteries
Battery Door
11 _=
6
47
7. Make sure that all parts are properly tightened before you use the exercise cycle. Note: There may be
some hardware left over after assembly Is completed. Cover the floor beneath the exercise cycle to pro-
tect the floor or carpet from damage.
5