First Steps - Kenmore 218621400A Owner's Manual

First Steps
3" AIR SPACE
Clearance
I Proper air circulation and leveling will
ensure efficient operation,
/
RAISE
Screw-type Levelers (some models)
LOWER
CABINET
CABINET
Exposed bolt (some models)
LOWER
CABINET
CABINET
Sunken bolt (some models)
Before starting the refrigerator, follow these important first steps:
Location
• Choose a place that is near a grounded electrical outlet DO NOT use an
extension cord or an adapter plug
• if possible, place the refrigerator out of direct sunlight and away from the
range, dishwasher or other heat sources
• The refrigerator must be installed on a floor that is level and strong enough
to support a fully loaded refrigerator,
° Consider water supply availability for models equipped with an automatic
ice maker
Installation
° Do not install the refrigerator where the temperature will drop below 60°F
(15°C) or rise above 110°F (43°C) The compressor will not be able to maintain
proper temperatures
* Ailow space around the unit for good air circulation, Leave a 1 inch (25 ram)
space behind and a 3 inch (75 mm) space above the refrigerator for adequate
circulation
, In a recessed installation, allow an extra 1/2 inch (t0-15 ram) on each side
for ease of installation.
o For best circulation, elevate the unit 1 inch (25 ram) from the floor, especially
if the floor is carpeted
Door Opening"
The doors should open to allow easy access to a counter when removing food
o Do not position the refrigerator so you have to walk around the refrigerator
doors
° Reverse the doors if necessary See "Reversible Door instructions "
Leveling
All four corners of refrigerator must rest firmly on a solid floor Some models are
equipped with adjustable screw-type levelers Others are equpped with rollers tf
your refrigerator did not come with rollers, they can be purchased from your dealer
• To adjust screw-type levelers (some models): Tip cabinet back slightly, and
raise and lower the adjusting bolts as needed,
, To adjust the front rollers (some models): Use a screwdriver, 3/8" socket
wrench, or nutdriver to adjust rollers as shown,
RAISE THE FRONT of cabinet enough so doors wilt close freely when opened
halfway Level cabinet side to side
Cleaning
• Wash the inside, all removable parts and the outside with mild detergent and
warm water Wipe dry DO NOT USE HARSH CLEANERS ON THESE
SURFACES.
° Do not use razor blades or other sharp instruments which can scratch the
appliance surface, when removing adhesive labels Any gtue feft from the
tape or energy label can be removed with a mixture of warm water and mild
detergent, or, touch the residue with the sticky side of tape already removed
• DO NOT REMOVETHE SERIALPLATE