First Steps - Kenmore 253.22052 Use & Care Manual

First Steps

This Use & Care Guide provides general
installation and operating instructions
for your model. We recommend using a
service or kitchen contracting professional
to install your appliance. Use the unit only
as instructed in this Use & Care Guide.
Before starting the appliance, follow
these important first steps.
Location
• Choose a place that is near a
grounded, non-GFCI, electrical outlet.
Do Not use an extension cord or an
adapter plug.
• For the most efficient operation, the unit
should be located where surrounding
temperatures will not drop below
0°F (-18°C) or exceed 110°F (43°C).
Additional compressor heaters are
not recommended. Models with
electromechanical temperature control
should not be located where the
surrounding temperature drops below
40°F (4°C). These models do not have
the automatic freeze control option to
prevent refrigerated food from freezing.
• Allow space around the unit for good
air circulation. Leave a 3" (75 mm)
space on all sides of the appliance for
adequate circulation.
3" (75 mm)
3" (75 mm)
3" (75 mm) Air Space
3" (75 mm)
NOTE
The exterior walls of the appliance
may become quite warm as the
compressor works to transfer heat from
the inside. Temperatures as much as
30°F warmer than room temperature
can be expected. For this reason it
is particularly important in hotter
climates to allow enough space for air
circulation around your unit.
Leveling
The unit must have all bottom corners
resting firmly on a solid floor. The floor
must be strong enough to support a fully
loaded appliance.
NOTE
It is Very Important for your appliance
to be level in order to function properly.
If the unit is not leveled during
installation, the door may be misaligned
and not close or seal properly, causing
cooling, frost, or moisture problems.
To Level Your Appliance:
Adjust the front leveling feet so that the
front of the appliance is slightly higher
above the floor than in the back. To test the
angle, the door should swing closed at a
light touch from a halfway open position.
Cleaning (Prior to use)
• Wash any removable parts, the appliance
interior, and exterior with mild detergent
and warm water. Wipe dry. Do not use
harsh cleaners on these surfaces.
• Do not use razor blades or other
sharp instruments, which can scratch
the appliance surface when removing
adhesive labels. Any glue left from the
tape can be removed with a mixture
of warm water and mild detergent, or
touch the residue with the sticky side of
tape already removed. Do not remove
the serial plate.
5