NEC NF2300-SR412E User Manual page 78

(4) Writing information on option label
To allow the options installed in the disk enclosure to be found by external view, the
label indicating the options available for the installation is put on the disk enclosure.
If a disk drive is added, write down the last two digits of model number and a check
mark at the corresponding field on the label to indicate the addition as shown in the
figure below.
Enter the last two digits of model
number ("13" in the example).
Note: The figure above indicates that a single NF2300-SM413E is installed at
location '03' in NF2300-SR412E.
If NF2300-SM412E is additionally installed in NF2300-SR412E, write down
check marks at the locations in which the disk drives are installed, which
appears in the area to the right of the model number field.
If the model number of disk drive additionally installed does not appear in the
model number field, enter the last two digits of model number in
"NF2300-SM4
the disk drive is installed, which appears in the area to the right of the model
number field.
If disk drives are installed at locations '03' and '04,' write down check marks
at the '03' and '04' fields.
Write down a check mark as shown in the figure.
(E)" field. Write down a check mark at the location in which
60