Table of Contents
Advertisement
(5) Inserting a new disk drive allows the data recovery to be started automatically.
If the auto repair feature is set to OFF, issue a recovery instruction
from the management software in manual mode to start recovery.
Otherwise, the reduced state ("reduce" shown as the logical disk
status) remains.
Setting the auto pair feature to ON in recovery wait state does not
start recovery. The setting is enabled starting with the next
recovery.
(6) The disk array unit operates normally during the data recovery. At the termination of
the data recovery, the SERVICE LEDs on the array controller and disk enclosure go
off.
101
Advertisement
Table of Contents
